12 Drive Control, Duty Modes, and Programming
YASKAWA TOEPC71061752B GA500 Drive Installation & Primary Operation 85
No.
(Hex.)
Name Description
b1-03
(0182)
Stopping Method
Selection
Sets the method to stop the motor after removing a Run command or entering a
Stop command.
0 : Ramp to Stop
1 : Coast to Stop
2 : DC Injection Braking to Stop
3 : Coast to Stop with Timer
b1-04
(0183)
Reverse Operation
Selection
Sets the reverse operation function. Disable reverse operation in fan or pump
applications where reverse rotation is dangerous.
0 : Reverse Enabled
1 : Reverse Disabled
C1-01
(0200)
RUN
Acceleration Time 1
Sets the length of time to accelerate from zero to maximum output frequency.
C1-02
(0201)
RUN
Deceleration Time 1
Sets the length of time to decelerate from maximum output frequency to zero.
C2-01
(020B)
S-Curve Time @ Start
of Accel
Sets the S-curve acceleration time at start.
C2-02
(020C)
S-Curve Time @ End
of Accel
Sets the S-curve acceleration time at completion.
C2-03
(020D)
S-Curve Time @ Start
of Decel
Sets the S-curve deceleration time at start.
C2-04
(020E)
S-Curve Time @ End
of Decel
Sets the S-curve deceleration time at completion.
C6-01
(0223)
Normal / Heavy Duty
Selection
Sets the drive duty rating.
0 : Heavy Duty Rating
1 : Normal Duty Rating
C6-02
(0224)
Carrier Frequency
Selection
Sets the carrier frequency for the transistors in the drive.
1 : 2.0 kHz
2 : 5.0 kHz (4.0 kHz for AOLV/PM)
3 : 8.0 kHz
4 : 10.0 kHz
5 : 12.5 kHz
6 : 15.0 kHz
7 : Swing PWM4 (Audible Sound 1)
8 : Swing PWM4 (Audible Sound 2)
9 : Swing PWM4 (Audible Sound 3)
A : Swing PWM4 (Audible Sound 4)
B : Leakage Current Rejection PWM
F : User Defined (C6-03 to C6-05)
To Next Page
Loading...
