YASKAWA GA800 Series - Main Circuit Terminal Block Wiring (Procedure A)

4 Maintenance
YASKAWA TOEPC71061779B GA800 Drive Installation Manual 41
Remove a Fan
1. To remove the fan finger guard from the drive, push the tabs on the left and right sides of it and pull up the
back side of the guard.
A - Fan finger guard
Figure 4.26 Remove the Fan Finger Guard
2. Pull the cooling fan straight up from the drive. Disconnect the power supply connector and remove the fan
from the drive.
A - Cooling fan
Figure 4.27 Remove the Cooling Fans
Install the Cooling Fans
Reverse the removal procedure to install a cooling fan.
1. Connect the power supply connector.
Figure 4.28 Connect the Power Supply Connector