YASKAWA GA800 Series - Main Circuit Terminal Block Wiring (Procedure B)

4 Maintenance
YASKAWA TOEPC71061779B GA800 Drive Installation Manual 45
2. Align the notches on the fan with the pins on the drive and install the cooling fan in the drive.
A - Notch on fan
B - Alignment pins on drive
C - Front of drive
Figure 4.36 Install the Cooling Fans
Note:
When you install the cooling fan, make sure that you do not pinch cables between the cooling fan and the drive.
3. Put the cable in the recess of the drive.
A - Front of drive
Figure 4.37 Put the Cable in the Drive Recess
4. Hold the fan finger guard at an angle and put the connector tabs on the fan finger guard into the holes on the
drive.
Note:
When you install the cooling fan, make sure that you do not pinch cables between the fan finger guard and the drive.