YASKAWA GA800 Series - Control Circuit Wire Gauges and Tightening Torques

4 Maintenance
YASKAWA TOEPC71061779B GA800 Drive Installation Manual 59
Remove a Fan
1. Remove the drive cover.
CAUTION
Crush Hazard. Loosen the cover screws. Do not fully remove them. If you fully remove the cover screws,
the terminal cover can fall and cause moderate injury.
2. Unplug the fan cables from the fan connectors.
A - Fan unit
B - Fan connector
C - Fan cable
Figure 4.62 Components
3. Loosen the fan unit screws.
Note:
To remove the fan unit, it is only necessary to loosen the Screws B.
Remove screws A.
A - Screws A B - Screws B
Figure 4.63 Loosen the Screws