YASKAWA GA800 Series - Setting Input Signals for MFAI Terminals

4 Maintenance
YASKAWA TOEPC71061779B GA800 Drive Installation Manual 65
A - Circuit board cooling fan
B - Fan unit base
C - Alignment pin on fan unit base
Figure 4.73 Install the Circuit Board Cooling Fan
Note:
When you install the circuit board cooling fan, make sure that you do not pinch cables between the circuit board cooling fan and
the fan unit base.
2. Put the fan unit into the specified location and use screws to safety it to the drive.
Tighten the screws to a tightening torque of 0.98 N∙m to 1.33 N∙m (8.67 in∙lb to 11.77 in∙lb).