Notes for Safe Operations
vii
154771-1CD
HW0485080
• Perform the following inspection procedures prior to conducting manipulator teaching. If problems
are found, repair them immediately, and be sure that all other necessary processing has been
performed.
-Check for problems in manipulator movement.
-Check for damage to insulation and sheathing of external wires.
• Always return the programming pendant to the hook on the NX100 cabinet after use.
The programming pendant can be damaged if it is left in the P-point maximum envelope
of the manipulator, on the floor, or near fixtures.
• Read and understand the Explanation of Warning Labels in the NX100 Instructions before
operating the EPX1750 & EPX2050.
To Next Page
Loading...
