YASKAWA SI-EP3 - Installation Procedure; Section Safety

5 Installation Procedure
18 YASKAWA ELECTRIC SIEP C730600 89C YASKAWA AC Drive Option SI-EP3 Technical Manual
 Procedure B
This section shows the procedure to install and wire the option on a GA700 or GA800 drive.
Prepare the Drive for the Option
Before you install the option on a YASKAWA AC Drive GA700, make sure that the option software version is PRG:
0253, 4400 or later.
Before you install the option on a YASKAWA AC Drive GA800, make sure that the option software version is PRG:
4400 or later.
1. Correctly wire the drive as specified by the manual packaged with the drive.
2. Make sure that the drive functions correctly.
Refer to Figure 10 for an exploded view of the drive with the option and related components for reference in the
installation procedure.
Figure 10
Figure 10 Drive Components with Option
A – Insertion point for CN5 connector I – LED Status Ring board
B – SI-EP3 option J – Connector CN5-A
C – Included screws K – Connector CN5-B
(Not available for communication option
installation.)
D – Drive front cover
E – LED label
F – Keypad L – Connector CN5-C
(Not available for communication option
installation.)
G – Option modular connector CN1 port 1
H – Option modular connector CN2 port 2
A1000
C
L
K
J
B
A
D
E
F
H
G
I
A1000