YASKAWA SI-EP3 - Procedure A

5 Installation Procedure
YASKAWA ELECTRIC SIEP C730600 89C YASKAWA AC Drive Option SI-EP3 Technical Manual 21
8. Reattach the drive front cover (D) and the keypad (F).
Figure 15
Figure 15 Replace the Front Cover and Keypad
9. Set drive parameters in Table 7 for correct option performance. Be sure to set parameter F6-30 to a node
address unique to the network.
 Communication Cable Specifications
Use only PROFINET dedicated communication cable; the Yaskawa warranty does not cover other cable types.
 Option Connection Diagram
Figure 16 Option Connection Diagram
<1> Connect the provided ground wire for installations on 1000-series drives.
The ground wire is not necessary for installation on GA700 or GA800 drives.
D
F
I
Install the keypad to the drive after replacing
the keypad connector and then the keypad
connector. At that time, insert the keypad
connector tab into the drive.
Keypad
connector
Tab
A1000
Drive
M
U/T1
V/T2
W/T3
R/L1
S/L2
T/L3
SI-EP3
PROFINET
Option
FE
<1>
PROFINET Master
PROFINET Cable
MotorPower
PROFINET Cable
A1000