Suspending angle:
50° or greater
Figure i.14 Drive Suspension Using Wires and Hanging Brackets
(Drive Models 2o0154 to 2o0248 and 4o0156 to 4o0414)
3. Gradually take up the slack in the wires and hoist the drive after the wires are stretched tight.
4. Lower the
drive when ready to install in the enclosure panel. Stop lowering the drive when it is near the floor, then slowly
begin lowering the drive again until the drive is placed correctly.
Drive Models 4
o
0477 to 4
o
0930
1. Pass wire through the holes of all four hanging brackets.
Suspending angle:
50° or greater
Figure i.15 Drive Suspension Using Wires and Hanging Brackets (Models 4o0477 to 4o0930)
2. Gradually take up the slack in the wires and hoist the drive after the wires are stretched tight.
3. Lower the
drive when ready to install in the enclosure panel. Stop lowering the drive when it is near the floor, then slowly
begin lowering the drive again very slowly until the drive is placed correctly.
Harmonic Filter Module
1. Pass wire through the holes of all four hanging brackets.
Suspending angle:
50° or greater
Figure i.16 Harmonic Filter Module Suspension Using Wires and Hanging Brackets (EUJ7118oo.o)
2. Gradually take up the slack in the wires and hoist the harmonic filter module after the wires are stretched tight.
3. Lower the
harmonic filter module when ready to install in the enclosure panel. Stop lowering the harmonic filter module
when it is near the floor, then slowly begin lowering the harmonic filter module again very slowly until the harmonic filter
module is placed correctly.
i.3 Mechanical Installation
YASKAWA ELECTRIC TOEP C710636 04D U1000 Industrial MATRIX Drive Quick Start Guide
23
To Next Page
Loading...
