4.3.13 FIN WAIT OCCURS BY SPINDLE RELATED
INSTRUCTION
The seq
and was
Tabl
Cause of Trouble
A signal identical with
the spindle speed is not
entered.
The axis zero speed
signal is not entered.
Other
uential
processing entered some signal wait mode
then discontinued.
4.42 Fin Wait Occurs
by
Spindle
Related
Instruction
Check Method
Solution
I
If this trouble occurs at the time of
commandl
If no trouble is found in the
issuing such as “ M03 S1OO”, etc., confirm wiring, there is a
possibil-
1/0 signal
pm3111
D,
= 1
(pm3121
DC
for
ity of a fault model JAN CD-
2nd-spindle).
FC800
board or fault spindle
Refer to the circuit diagram of the machine
drive unit.
manufacturer to confirm 1/0 input section
Contact your
YASKAN7A
1/0 signal #1000 level.
representative.
If this trouble occurs at stop time “ M05°,
If no trouble is found in the
refer to the circuit diagram of the machine
wiring, there is a
possibil-
manufacturer to confirm 1/0 input section
ity of a fault model
JANCD -
1/0 signal #1000 level.
FC800 board or fault spindle
drive unit.
If this trouble occurs at the time of “ M19°
If no trouble is found in the
or “M20”,
spindle orientation command, wiring, there is a possibility
refer to the circuit diagram of the machine
of a fault model
JANCD -
manufacturer to confirm the 1/0, especially
FC800 board or fault spindle
the orientation-related sections.
drive unit.
Contact your
YASKA\VA
representative.
-.
125
To Next Page
Loading...