YASKAWA YASNAC i80 - Display and Writing of Fixed Files

8.2 DISPLAY AND WRITING OF FIXED FILES
Each fixed file permits screen display, writing, and 1/0
verification.
Table 8.1
Display, Writing, and
1/0 Verification of Fixed Files
Item
Parameter
Parameter
-
~
1/0
*
Display Screen and
Write Process
System No.
~ Interlock ,
v;::;:::~
System No.
Interlock
Maintenance Available
Maintenance Available
maintenance, Drive
Not available
Maintenance Not available
Maintenance Available
Maintenance
Available
Maintenance Available
Maintenance Available
Step
I Not available
I Maintenance
Not available
Offset
Workpiece
Coordinate System
Step
Not available
Maintenance
Not available
I
I
TOO I Life Management
Step
Not available
Maintenance
Not available
I
I
[
Macro Program Common Variable
Drive
Not available
Maintenance
Not available
I
1- 1 I
-
System number and interlock have the following rules:
o 1.
2.
3.
4.
5.
For writing of parameters and keep memory, system number must be set to 1.
A system number is set by the parameter replacement switch on the control panel
or to the value
pmO109.
Setting of parameter replacement switch
OFF: SYSTEM ( pmO109 = O). Normal operation is performed
Writing of parameters is prohibited,
ON: PARAMETER
(pmO109 = 1). Selected to write parameters.
Cycle start is prohibited.
When other than the values shown above is specified, normal operation cannot be
guaranteed.
Effective only when the system number switch on the
FC200 board is set to O.
System number setting
pmO109 must be used as O, except when writing parameters
205