YASKAWA YASNAC i80 - NC Rack; Power Supply Unit

6.1
6.1.1
NC RACK
POWER SUPPLY UNIT (MODEL CPS-12N, MODEL CPS-16F)
MOUNTING SCREW -
INDICATION LAMP
{
CONNECTOR
[
‘U .
x
““ IvIOUNTING SCREW
-MOUNTING SCREW
w
.0
~
- MOUNTING -
SCREW
INDICATION LAMP
{
1
CONNECTOR
fid~OLJNTING scREw
Model CPS-12N Model CPS-16F
(1)
Removal
(a)
(b)
Check that AC input power is not supplied [the
SOURCE indication lamp (green) of the power
supply unit is off], then pull out the CN03, CN04,
and CN05 cables.
Loosen the mounting screws in the three positions
in the figure and r;move the power suppiy unit
from the NC rack.
(2) Installation
(a)
(b)
(c)
,-.
Insert the power supply unit in line with the guide
of the NC rack.
Loosen the mounting screws in the three positions
in the figure.
Insert the CN03, CN04, and CN05 cables into the
original positions.
144