6.1
6.1.9
NC RACK (Cent’d)
MODEL
JANCD-FC300B-3
(1) Removal
~;-------
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
1
J
R
u>
FC300 B
1
4
(a) Check that AC input power is not supplied [the
SOURCE indication lamp (green ) of the power unit
is off], then pull out the
CN30,
CN31,
and CN32
cables.
(b) Loosen the mounting screw in the figure and
remove the module from the NC rack.
(2) Installation
See the figure for the exterior of the module.
(a)
.
.
(b)
Check the model and REV number of the replacement
module for consistency.
Check that the ROM number and label contents of
the replacement module are the same as those of the
module to be replaced.
160
To Next Page
Loading...