8.1 TYPES OF FIXED FILES
Types of fixed files are shown below.
The asterisk (*)
indicates an option.
*
(a) Parameter
~
Parameter
k
Setting
Keep memory & sequence parameter
Pitch error correction parameter (*)
(b)
Offset
— Tool offset
1
Work coordinate system shift
(c) Tool life management data (*)
(d) Macro program common variables (*)
~
@-
This unit places various parameters in internal memory.
According to their contents, unit operation conditions such
as tape codes and rapid feed speeds are determined.
Parameters can be displayed at all times, including during
automatic operation, regardless of the mode.
For the contents of parameters, refer to Section
9
II
PARAMETER
NUMBERS” of Appendix (TOE
-C843-11.
31) of
YASNAC i80M Instruction Manual or Appendix (TOE-C843-
11. 21) of YASNAC i80L Instruction Manual.
For the contents of sequence parameters
(pm7000
to
pm7099)
,
refer to the manual issued by the machine manufacturer.
Keep memory contains important in formation for controlling g
machine sequences,
which is held even when power is turned
off.
Incorrect setting may lead to machine trouble.
Great care should be taken according to the manual issued
by machine manufacturer.
204
To Next Page
Loading...