5. ADJUSTMENTS UPON INSTALLATION (Cent’d )
(4)
(5)
(6)
(7)
Connect the Power Input
Cable.
Before connecting the
power input cable, verify
that power input terminals
R, S, and T inside the unit
are not shorted.
Check Connector and Module
Locations and Insertions.
●
Check that
the module
ghtened on
“
Check that
the screws on
clamps are ti-
the CPU rack.
the clamp
claws on Honda connectors
are tightened and that
clamp screws are securely
in place.
●
Check that the clamp
claws on power supply
connectors are in place.
●
Check that the clamp
claws on flat cables are
in place.
Check Setting.
Verify the control power
transformer setting in refer-
ence to the input power
supply voltage.
Check Input Power Supply
Voltage and Frequency.
●
Check that the power
Don’t cause
short.
Qo
nn
-o
Power
J<
R
input
S termi nal
T
\
4
SCREWDRIVER
supply voltage and
fre-
OQ
Input power
&l
quency meet ratings.
“
Check that the input
supply,
00
voltage,
G
power supply capacity is
frequency
high enough for power
consumption of the
1
control unit,
138
To Next Page
Loading...