(c)
Set
SW1 on the module as it was before
replacement.
(d) Insert the module in line with the guide of the NC
rack and tighten mounting screw.
(e) Insert the CN1O and
CN1l
cables into the original
positions.
(3) Checking Functions After Replacement
(a)
Check that
+5V,
+
12V, and
+24V
outputs are not
shorted due to overloading.
(b) Check that the initial is screen is displayed by
initially applying power to the NC.
(c)
Check
that keys on the control panel can be
operated.
(d)
With model JANCD-FC903, check that switches on the
machine control panel can be operated.
147
To Next Page
Loading...