6.2 MACHINE CONTROL STATION (Cent’d)
6.2.1.3 MODEL JANCD-FC903-1
P
MOUNTING SCREW
B8
“
MOUNTING SCREW
++’p
m
MOUNTING SCREW
MOUNTING SCREW
+&
(1) Removal
(a)
Check that AC input power is not supplied [the
SOURCE indication lamp (green ) of the power unit
is off], then pull out cables connected to CN21,
CN24, CN25,
CN26,
CN27,
CN28, and CN29 of model
(b)
JANCD-FC903-1O
Loosen the mounting screws of model
and remove model JANCD-FC903 from
panel.
(2) Installation
See the figure for the exterior of the
(a)
(b)
-.
(c)
(d)
Check the model and REV number of
module for consistency.
Check that the setting of
SW1
is the
before replacement.
JANCD-FC900B
the control
module.
the replacement
same as that
Install model JAN
CD-FC903-1
on the control panel
according to the figure.
Insert all cables to the original positions.
188
To Next Page
Loading...