Advanced Call Features
38
Before You Begin
Check with your system administrator if the group call pickup code is required for this key. If required, get the group
call pickup code from your system administrator.
Procedure
1.
1.
Tap Dsskey.
2.
Long tap the desired line key.
3. Select Key Event from the Type field.
4. Select Group Pick Up from the Key Type field.
5. Select the desired line from the Account ID field.
6.
Do one of the following:
l
(Optional.) Enter the string that will appear on the phone screen in the Label field.
Enter group call pickup code in the Value field.
l
Select and select the desired contact.
7.
Select .
When any phone within a predefined group of phones receives an incoming call, you can the Group Pickup key,
and the call is answered on your phone.
Call Park and Call Retrieve
You can park a call, and then retrieve the call either from your phone or another phone. After parked, the call is
placed on hold, you can continue the conversation after retrieving it.
Note: Call park is not available on all servers. Check with your system administrator to find out if it is available on your
phone.
Topics
Parking or Retrieving a Call in the FAC Mode
Parking or Retrieving a Call in the Transfer Mode
Parking or Retrieving a Call in the FAC Mode
You can park the call to the local extension or the desired extension through dialing the park code.
Topics
Parking a Call in the FAC Mode
Retrieving a Parked Call in the FAC Mode
Parking a Call in the FAC Mode
You can park a call in the FAC mode directly. When you park a call to the local extension or the desired extension,
the call is held in the same network on your phone.
Before You Begin
Your system administrator has set call park in the FAC mode.
Procedure
1.
During a call, select > Park.
The phone will dial the call park code which is pre-configured.
To Next Page
Loading...
