Yealink CP925 - Connecting to the Wireless Network Using WPS; Adding a Wireless Network Manually

Yealink CP925 User Guide
83
Connecting to the Wireless Network Using WPS
The Wi-Fi protected setup (WPS) provides simplified mechanisms to configure secure wireless networks which can
automatically configure a wireless network with a network name (SSID) and strong WPA data encryption and
authentication.
There are two supported methods in the Wi-Fi protected setup:
l
Push Button Configuration (PBC): The user simply has to press the WPS key on both the phone and gate-
way/router to connect.
l
Personal Identification Number (PIN): The user enters the PIN generated randomly by the phone on the gate-
way/router to connect.
Before You Begin
Make sure that the Wi-Fi mode is activated.
Procedure
1. Go to More > Basic > Wi-Fi.
2.
Do one of the following:
l
Select > WPS to use the PBC method, then long press the WPS key on your gateway or router.
Once the WPS setup has completed successfully, the phone screen will prompt “Connect Success.”.
l
Select > WPS-PIN to use the PIN method, then log into your gateway or router’s web interface, and con-
figure it to search the clients. For more information, refer to the documentation from the gateway or router man-
ufacturer.
Once WPS-PIN setup has completed successfully, the web interface of the gateway or router will prompt that
the connection is successful.
Related Topic
Activating the Wi-Fi Mode
Adding a Wireless Network Manually
If SSID broadcast on your gateway or router is disabled, the wireless network might not appear in the scanning res-
ults. In that case, you must manually add a wireless network.
The phone can store up to 5 connected wireless networks.
Before You Begin
Get the available wireless network information from your system administrator. Make sure that the Wi-Fi mode is
activated.
Procedure
1. Go to More > Basic > Wi-Fi.
2.
Tap Known Network(s) and select .
3. Enter the desired SSID in the SSID field.
3.
Do the following:
l
Select None from the Security Mode field.
l
If you select WEP, WPA/WPA2 PSK from the Security Mode field, enter the desired password.
l
If you select 802.1x EAP from the Security Mode field, select the desired EAP method and enter the desired
values in the corresponding fields.
4. Select Save.
The connected wireless networks will be saved to the Known Network(s) list.