| Setting the Camera | 25
Parameter Description
Shutter
Configure the value of the shutter.
Value: 1/60, 1/90, 1/100, 1/125, 1/180, 1/250, 1/350, 1/500, 1/725,
1/1000, 1/1500, 1/2000, 1/3000, 1/4000, 1/6000, 1/10000
Default: 1/100.
Configuring the Mode of Brightness Priority
Procedure
1. On the idle screen, tap Settings > General > System Settings > Exposure Settings.
2. Select Brightness Priority from the pop-up menu of Exposure mode.
3. Configure and save the following settings:
Parameter Description
Wide Dynamic
Range
Off or Specify the WDR. The value represents the compression degree of the
dynamic range
Cameras with WDR technology can work perfectly both in the bright and the
dark conditions and present clear images that balances different lighting, so
that you can identify the details.
• Off-do not use WDR.
• 1~5
Default: Off.
Brightness
Configure the value of brightness.
Note: the valid value is from 0 to 14 and the default value is 6.
Flicker
Configure the value of camera flicker frequency.
The supported types are as follows:
• 50 Hz
• 60 Hz
• Off
The indoor lights powered by a 50 Hz or 60 Hz power sources may produce
a flicker. You can adjust the camera flicker frequency according to the power
source that the light is powered by.
Default: 50 Hz.
Metering
Configure the value of metering.
• Average
• Middle Zone
• Bottom
• Top
Default: Average.
To Next Page
Loading...
