| Network Settings | 35
4. Configure and save the following settings:
Parameter Description
Activated
Enable or disable the LLDP feature on the
system.
Note: it defaults to disabled.
Change causes system to restart or reboot.
Packet Interval (1-3600s)
Configure the interval (seconds) for the system to
send LLDP requests.
Note: it defaults to 60 seconds. The value can be
any integer from 1 to 3600.
Change causes system to restart or reboot.
Configuring the 802.1x Authentication
The 802.1X protocol can restrict unauthorized devices from accessing the LAN through the access port.
Before the system/controller obtains all the businesses, the 802.1x authentication authenticates the device
connected to the port.
About this task
The system/controller supports the following protocols for 802.1X authentication:
• EAP-MD5
• EAP-TLS (Device and CA certificates are required, password is not required)
• PEAP-MSCHAPv2 (CA certificates are required)
• EAP-TTLS/EAP-MSCHAPv2 (CA certificates are required)
Note: If you choose the protocol that requires CA certificate, you can go to the web user
interface of the system/controller to upload certificates (go to Network > Advanced > 802.1x).
Procedure
1. On the idle screen, tap Settings > General > System Settings > Network.
2. Enter the administrator password (default: 0000) and tap Enter.
3. Select Collar Bar/Touch Console.
4. Configure and save the following settings:
Parameter Description
802.1xMode
Disable the 802.1x authentication or select the
desired mode.
• Disabled
• EAP-MD5
• EAP-TLS
• PEAP-MSCHAPv2
• EAP-TTLS/EAP-MSCHAPv2
Note: it defaults to disabled.
Change causes system to restart or reboot.
To Next Page
Loading...
