Yealink MeetingBar A30 - Recommendations of CTP18 Installation; Powering on or off; Initial Setup; Pairing CTP18 with Meetingbar A20

| Deployment and Connection | 10
• Deployment and Connection of MeetingBar A30
• Recommended Deployment Solution of MeetingBar A30 for Zoom Rooms
Major updates have occurred to the following sections:
• Technical Specifications
• Enabling/Disabling Auto Framing
• MeetingBar A20/A30 Installation
• System Lock Settings
The following section is removed:
• Setting the Hangup Mode
Changes for Guide Version 1.1
From this version, you are not required to import a certificate for upgrading devices from Teams to Zoom
Rooms version.
Major updates have occurred to the following sections:
• Upgrading the Firmware
Deployment and Connection
This chapter mainly introduces the deployment and connection of MeetingBar A20/A30 for Zoom Rooms.
CTP18 is connected to MeetingBar A20/A30 in the same LAN through IP pairing, and acts as the controller
for Zoom Rooms.
• Deployment and Connection of MeetingBar A20
• Deployment and Connection of MeetingBar A30
• Deployment and Connection of CTP18
• Recommended Deployment Solution