User Guide SIP-T20P IP Phone
46
Using the headset
You can also dial the number first, and then choose the way you want to speak to the
other party.
You can search the call history, the local contact directory and dial from the search
results. For more information, refer to Contact Management on page 24 and Call History
Management on page 28.
During a call, you can alternate between Speakerphone, Headset, or Handset modes
by pressing the Speakerphone key, HEADSET key, or picking up the handset.
The call duration of active calls is visible on the LCD screen. In the figure below, the call
to John has lasted 1 minute and 6 seconds.
To place a call using the handset:
1. Pick up the handset.
2. Enter the desired number using the keypad.
3. Press or .
By default, the # key is set as send. You can set the * key as send key or set neither of
them as send keys. For more information, refer to Key as Send on page 19.
Note
To place a call using the hands-free speakerphone mode:
Do one of the following:
- With the handset on-hook, press or the line key to obtain a dial tone.
Enter the desired number using the keypad.
Press or .
- With the handset on-hook, enter the desired number using the keypad.
Press , or .
You can also dial using the SIP URI or IP address. To obtain the IP address of your phone,
press the OK key. The maximum SIP URI or IP address length is 32 characters. For
example, IP: 192.168.1.15, SIP URI: 2210@sip.com.
Your phone may not support direct IP dialing. Contact your system administrator for more
information.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
