Basic Call Features
61
3. Press or to dial out.
4. After the party answers the call, press to complete the transfer.
If you are using a handset, the transfer can be completed by hanging up the handset.
You can cancel the transfer before the call is connected by pressing .
You can enable or disable the call waiting feature on the phone. If the call waiting
feature is enabled, you can receive another call when there is an active call on the
phone. If the call waiting feature is disabled, another incoming call is automatically
rejected by the phone with a busy message when there is an active call on the phone.
You can also enable the play tone feature to hear a warning tone when receiving
another call.
To configure call waiting via phone user interface:
1. Press .
2. Select Features->Call Waiting.
3. Press or to select Enable from the Call Waiting field.
4. Press or to select Enable from the Play Tone field.
5. (Optional.)Enter the call waiting on code or off code respectively in the CW On
Code or CW Off Code field.
6. Press to accept the change.
You can also configure the call waiting feature via web user interface at the path
Phone->Features->General Information>>.
You can create a conference with other parties using the phone’s local conference
feature. You can create a conference between an active call and a call on hold (on the
same or another line) by pressing the CONF key. The network conference feature allows
you to add specific conference parties.
Note
To Next Page
Loading...
Need help?
General
Weight and Dimensions
