Yealink SIP-T20P User Manual

Advanced Phone Features
71
In the following figure, the phone LCD screen shows an incoming call from 1007 on the
monitored user.
When there is a conversation on the IP phone, you can handle the active call differently
depending on the transfer mode on DSS key.
To configure the transfer mode on DSS key via web user interface:
1. Click on Phone->Features->Transfer Settings>>.
2. Select the desired transfer mode from the pull-down list of Transfer Mode via
DSSkey. Depending on your selection:
- If you select Blind Transfer, press the BLF key to complete the blind transfer to
the monitored phone number.
- If you select Attended Transfer, press the BLF key to dial out the monitored
phone number and then you can complete the attended or semi-attended
transfer.
- If you select New Call, press the BLF key to place a new call to the monitored
user.
For more information on performing call transfer, refer to Call Transfer on page 60.
3. Click Confirm to accept the change.
1.
1006<-1007

Yealink SIP-T20P Specifications

General

Keypad number of keys	31
Speakerphone	Yes
Voice codecs	G.711, G.722, G.723.1, G.726
Mounting	Desk/Wall
Handset type	Wired handset
Product type	IP Phone
Product color	Black
Touchscreen	-
Lines quantity	2 lines
Phonebook capacity	1000 entries
Number of VoIP accounts	2
Bluetooth	No
Security algorithms	HTTPS, SSL/TLS
AC adapter input voltage	100 - 240 V
AC adapter output voltage	5 V
Power consumption (typical)	2.6 W
Operating relative humidity (H-H)	10 - 95 %
Compliance industry standards	IEEE 802.3af
Number of handles included	1 pc(s)

Weight and Dimensions

Depth	200 mm
Width	185 mm
Height	90 mm
Weight	770 g