Yealink SIP-T27P

Basic Call Features
91
To place a call using the hands-free (speakerphone) mode:
Do one of the following:
- With the handset on-hook, press or the line key to obtain a dial tone.
Enter the desired number using the keypad.
Press , or the Send soft key.
- With the handset on-hook, enter the desired number using the keypad.
Press , , or the Send soft key.
To place a call using the headset:
Do one of the following:
- With the optional headset connected, press to activate the headset mode.
Press the line key to obtain a dial tone.
Enter the desired number using the keypad.
Press , , or the Send soft key.
- With the optional headset connected, press to activate the headset mode.
Enter the desired number using the keypad.
Press , , or the Send soft key.
Note
The SIP-T27P IP phone can handle multiple calls at a time. However, only one active call (the call
that has audio associated with it) can be in progress at any time, other calls are placed on hold.
The SIP-T27P IP phone can handle a maximum of 50 calls at one time.
To place multiple calls:
You can have more than one call on your SIP-T27P IP phone. To place a new call during an
active call, do one of the following:
- Press the line key. The active call is placed on hold.
Enter the desired number using the keypad.
Press , , or the Send soft key.
- Press or the Hold soft key to place the original call on hold.
Press the New Call soft key.
Enter the desired number using the keypad.
Press , , or the Send soft key.
To permanently use the headset mode, refer to Headset Prior on page 63.