Yealink SIP-T27P

User Guide for the SIP-T27P IP Phone
64
To enable headset prior via web user interface:
1. Click on Features->General Information.
2. Select Enabled from the pull-down list of Headset Prior.
3. Click Confirm to accept the change.
To use headset prior, you should activate the headset mode in advance:
1. Physically connect the headset.
2. Press to activate the headset mode.
Note
Dual Headset
You can use two headsets when dual headset feature is enabled. To use this feature, you must
physically connect headsets to the headset jack and handset jack respectively. Once the phone
connects to a call, the headset connected to the headset jack will have full-duplex capabilities,
while the one connected to the handset jack will only be able to listen.
If headset prior is enabled, the headset mode will not be deactivated until you press the
HEADSET key again.
If headset prior is disabled, the headset mode can be deactivated by pressing the Speakerphone
key or the HEADSET key.
Headset prior is configurable via web user interface only.