Yealink T42S

Call Features
289
Values
1-Enabled
Default
1
Parameter
dialplan.digitmap.apply_to.prefix_key
<y0000000000xx>.cfg
Description
It enables or disables the phone to apply the predefined string of the digit map after
pressing a Prefix key.
Note: It works only if “dialplan.digitmap.enable” or
“account.X.dialplan.digitmap.enable” is set to 1 (Enabled).
Permitted
Values
0-Disabled
1-Enabled
Default
1
Parameter
dialplan.transfer.mode
<y0000000000xx>.cfg
Description
It configures the transfer type the IP phone will perform when the entered transferee
numbers match the Dial Now rule of dial plan.
Note: It is only applicable to old dial plan mechanism.
Permitted
Values
0-Semi-attended Transfer/Attended Transfer
1-Blind Transfer
Default
0
Digit Map for a Specific Line Configuration
The following table lists the parameters you can use to configure digit map for a specific line.
Parameter
account.X.dialplan.digitmap.enable
[1]
<MAC>.cfg
Description
It enables or disables the digit map feature for the account X.
Note: The value configured by the parameter “account.X.dialplan.digitmap.enable”
takes precedence over that configured by the parameter “dialplan.digitmap.enable”.
Permitted
Values
0-Disabled
1-Enabled
Default
0
Parameter
account.X.dialplan.digitmap.string
[1]
<MAC>.cfg
Description
It configures digit map pattern used for the dial plan.
Example:
account.1.dialplan.digitmap.string = <[2-9]x:86>3.T|0x.!|1xxx
Note: The string must be compatible with the digit map feature of MGCP described in
2.1.5 of RFC 3435. It works only if “account.X.dialplan.digitmap.enable” is set to 1
(Enabled). The value configured by the parameter “account.X.dialplan.digitmap.string”