Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series IP Phones
324
features.dnd.feature_key_sync.local_processing.enable
It enables or disables the local DND when DND feature synchronization is enabled.
Note: It works only if s “features.feature_key_sync.enable” and
“features.dnd.feature_key_sync.enable” are set to 1 (Enabled). The value configured by
the parameter “account.X.features.dnd.feature_key_sync.local_processing.enable”
takes precedence over that configured by this parameter.
0-Disabled, DND is performed on server side only.
1-Enabled, DND is performed on both server side and locally.
account.X.features.dnd.feature_key_sync.local_processing.enable
[1]
It enables or disables the local DND when DND feature synchronization is enabled.
Note: It works only if s “features.feature_key_sync.enable” and
“features.dnd.feature_key_sync.enable” are set to 1 (Enabled).
0-Disabled, DND is performed on server side only.
1-Enabled, DND is performed on both server side and locally.
[1]
X is the account ID. For T54S/T48S/T48G/T46S/T46G/T29G, X=1-16; for T52S/T42G/T42S, X=1-12; for
T41P/T41S/T27P/T27G, X=1-6; for T40P/T40G/T23P/T23G, X=1-3; for T21(P) E2, X=1-2.
Multiple Call Appearances
You can enable each registered line to support multiple concurrent calls. For example, you can place one
call on hold, switch to another call on the same registered line, and have both calls displayed.
You can set the maximum number of concurrent calls per line key on all-lines basis or a per-line basis. For
example, if you specify 3 concurrent-calls for account 1, you can only have three call appearances on a
corresponding line key. The additional incoming calls will be rejected.
The number of concurrent calls applies to all line keys. For example, if three line keys are associated
with an account, you can have three call appearances per line key.
Topic
Multiple Call Appearances Configuration
Multiple Call Appearances Configuration
You can specify the maximum concurrent-call numbers per line key.
To Next Page
Loading...
