Yealink T42S - Page 396

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series IP Phones
376
Default
0
Parameter
voice.tone.secondary_dial
<y0000000000xx>.cfg
Description
It customizes the secondary dial tone.
The value format is Freq/Duration. For more information on the value format, refer to
the parameter “voice.tone.dial”.
Note: It works only if “voice.tone.country” is set to Custom. If you want to disable this
warning tone, set it to 0.
Permitted
Values
String
Default
350+440/3000
Web UI
Settings->Tones->Secondary Dial
Parameter
voice.tone.ring
<y0000000000xx>.cfg
Description
It customizes the ringback tone.
The value format is Freq/Duration. For more information on the value format, refer to
the parameter “voice.tone.dial”.
Note: It works only if “voice.tone.country” is set to Custom. If you want to disable this
warning tone, set it to 0.
Permitted
Values
String
Default
Blank
Web UI
Settings->Tones->Ring Back
Parameter
voice.tone.busy
<y0000000000xx>.cfg
Description
It customizes the tone when the callee is busy.
The value format is Freq/Duration. For more information on the value format, refer to
the parameter “voice.tone.dial”.
Note: It works only if “voice.tone.country” is set to Custom. If you want to disable this
warning tone, set it to 0.
Permitted
Values
String
Default
Blank
Web UI
Settings->Tones->Busy
Parameter
voice.tone.congestion
<y0000000000xx>.cfg
Description
It customizes the tone when the network is congested.
The value format is Freq/Duration. For more information on the value format, refer to
the parameter “voice.tone.dial”.