Yealink T42S

Phone Network
41
Parameter
static.network.pc_port.enable
[1]
<y0000000000xx>.cfg
Description
It enables or disables the PC port.
Permitted
Values
0-Disabled
1-Auto Negotiation
Default
1
Web UI
Network->PC Port->PC Port Active
Parameter
static.network.internet_port.speed_duplex
[1]
<y0000000000xx>.cfg
Description
It configures the transmission method of the Internet port.
Note: For T54S/T52S/T48S/T48G/T46S/T46G/T42G/T42S/T40G/T29G/T27G/T23G IP
phones, you can set the transmission speed to 1000Mbps/Auto Negotiation to
transmit in 1000Mbps if the IP phone is connected to the switch supports Gigabit
Ethernet. We recommend that you do not change this parameter.
Permitted
Values
0-Auto Negotiation
1-Full Duplex 10Mbps
2-Full Duplex 100Mbps
3-Half Duplex 10Mbps
4-Half Duplex 100Mbps
5-Full Duplex 1000Mbps (only applicable to
T54S/T52S/T48S/T48G/T46S/T46G/T42G/T42S/T40G/T29G/T27G/T23G IP phones)
Default
0
Web UI
Network->Advanced->Port Link->WAN Port Link
Parameter
static.network.pc_port.speed_duplex
[1]
<y0000000000xx>.cfg
Description
It configures the transmission method of the PC port.
Note: It works only if “static.network.pc_port.enable” is set to 1 (Auto Negotiation). For
T54S/T52S/T48S/T48G/T46S/T46G/T42G/T42S/T40G/T29G/T27G/T23G IP phones, you
can set the transmission speed to 1000Mbps/ Auto Negotiation to transmit in
1000Mbps if the IP phone is connected to the switch supports Gigabit Ethernet. We
recommend that you do not change this parameter.
Permitted
Values
0-Auto Negotiation
1-Full Duplex 10Mbps
2-Full Duplex 100Mbps
3-Half Duplex 10Mbps
4-Half Duplex 100Mbps
5-Full Duplex 1000Mbps (only applicable to
T54S/T52S/T48S/T48G/T46S/T46G/T42G/T42S/T40G/T29G/T27G/T23G IP phones)