Yealink T54S

Phone Customization
117
Topic
Label Length Display Configuration
Label Length Display Configuration
The following table lists the parameters you can use to configure the label length display.
Parameter
features.config_dsskey_length
<y0000000000xx>.cfg
Description
It configures the label length displayed on the idle LCD screen for the line key.
Note: It is only applicable to T54S/T48S/T48G/T46S/T46G/T29G IP phones.
Permitted
Values
0-Default
1-Extended
2-Mid Range (only applicable to T54S/T46S/T46G/T29G IP phones)
Default
0
Web UI
Dsskey->Line Key->Label Length
Parameter
features.shorten_linekey_label.enable
<y0000000000xx>.cfg
Description
It enables or disables the IP phone to display the length of the line key label within 9
digits.
Note: It works only if “features.config_dsskey_length” is set to 0 (Default). It is only
applicable to T54S/T52S/T48S/T48G/T46S/T46G/T29G IP phones.
Permitted
Values
0-Disabled, the line key label can display at most 8 digits.
1-Enabled, the line key label can display at most 9 digits.
Default
0
Label Alignment for Line/Ext Key Display
You can customize the line/ext key label alignment.