Yealink T54S

Troubleshooting
546
Broadsoft Visual Voice Mail
Parameter
bw.voice_mail.visual.enable
<y0000000000xx>.cfg
Description
It enables or disables the visual voice mail feature for the IP phone.
Note: It works only if “bw.xsi.enable" is set to 1 (Enabled) and XSI is configured for
account 1.
Permitted
Values
0-Disabled
1-Enabled
Default
0
Parameter
bw.voice_mail.visual.display_videomail.enable
<y0000000000xx>.cfg
Description
It enables or disables the IP phone to display the video mails in the voice mail list.
Note: It works only if the values of the parameters "bw.xsi.enable" and
"bw.voice_mail.visual.enable" are set to 1 (Enabled) and XSI is configured for account
1.
Permitted
Values
0-Disabled
1-Enabled
Default
0
Parameter
voice_mail.message_key.mode
<y0000000000xx>.cfg
Description
It configures the phone behavior when pressing the MESSAGE key when the IP phone
is idle.
Permitted
Values
0-enter the Set Voice Mail Code screen if the voice mail access code has not been
configured; dial out the voice mail access code if the voice mail access code has been
configured.
1-enter the View Voice Mail screen
Default
0
Broadsoft SCA
Parameter
account.X.share_line.barge_in.enable
[1]
<MAC>.cfg
Description
It enables or disables the users to interrupt/barge into an active call on shared line.
Note: It is not applicable to T19(P) E2 IP phones.
Permitted
Values
0-Disabled
1-Enabled
Default
1