Yealink T54S

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series IP Phones
158
Notification Popups Configuration
The following table lists the parameters you can use to configure notification popups.
Parameter
features.voice_mail_popup.enable
<y0000000000xx>.cfg
Description
It enables or disables the IP phone to pop up the message when it receives a new
voice mail.
If the message disappears, it will not pop up again unless the user receives a new
voice mail or the user re-registers the account that has unread voice mail(s).
Note: It works only if “account.X.display_mwi.enable” is set to 1 (Enabled).
Permitted
Values
0-Disabled
1-Enabled
Default
1
Web UI
Features->Notification Popups->Display Voice Mail Popup
Parameter
features.voice_mail_alert.enable
<y0000000000xx>.cfg
Description
It enables or disables the IP phone to pop up the message when receiving the same
amount of new voicemails.
Permitted
Values
0-Disabled
1-Enabled
Default
0
Parameter
features.missed_call_popup.enable
<y0000000000xx>.cfg
Description
It enables or disables the IP phone to pop up the message when it misses a call.
Note: It works only if “account.X.missed_calllog” is set to 1 (Enabled).
Permitted
Values
0-Disabled
1-Enabled
Default
1
Web UI
Features->Notification Popups->Display Missed Call Popup
Parameter
features.forward_call_popup.enable
<y0000000000xx>.cfg
Description
It enables or disables the IP phone to pop up the message when it forwards an
incoming call to other party.
Permitted
Values
0-Disabled
1-Enabled
Default
1
Web UI
Features->Notification Popups->Display Forward Call Popup