Yealink T54S

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series IP Phones
186
Macro Action
Description
 Headset
 Mute
 Message
 Hold
 Redial
 Transfer
 Speaker
 Conference
 ExtX@Y (X stands for the serial number of expansion
module key, Y stands for the serial number of
expansion module; For T48S/T48G/T46S/T46G/T29G:
X ranges from 1 to 40, Y ranges from 1 to 6; For
T54S/T52S: X ranges from 1 to 60, Y ranges from 1 to
3; @Y can be omitted if there is only one expansion
module connected to the phone.)
 Menu (You can enter menu by executing this
command at any interface except the
non-executable situations. For example, entering
menu is blocked during an active call.)
 Home (You can return back to idle screen by
executing this command at dialing screen for T48S/G
IP phones)
Example: $KDialPadPound$ means pressing the pound
key.
Note: If a key (for example, Redial key) is not found but
the function is available, perform the corresponding
action. If a key is not found and the function is
unavailable, the execution of the action string will be
ignored.
$I<menu item ID>$
The action to position and enter the desired menu item.
Each menu item has a unique identifier on the IP phone,
you can configure this parameter according to the
system-defined menu item ID. If the menu item ID is not
defined on the phone or there is no matched menu item
on the current screen, the execution of the action string
will be ignored. The menu item ID is case-insensitive.
Example: $Istatus_list& means entering the Status menu.
Note: To view the menu item ID, you can set