Yealink T54S

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series IP Phones
196
Default
0
Parameter
softkey.X.use.hold
[1]
<y0000000000xx>.cfg
Description
It enables or disables the custom soft key X to be displayed in the hold state.
Note: It works only if the values of the parameters
“features.enhanced_dss_keys.enable” and “softkey.X.enable” are set to 1 (Enabled).
Permitted
Values
0-Disabled
1-Enabled
Default
0
Parameter
softkey.X.use.held
[1]
<y0000000000xx>.cfg
Description
It enables or disables the custom soft key X to be displayed in the held state.
Note: It works only if the values of the parameters
“features.enhanced_dss_keys.enable” and “softkey.X.enable” are set to 1 (Enabled).
Permitted
Values
0-Disabled
1-Enabled
Default
0
Parameter
softkey.X.use.conferenced
[1]
<y0000000000xx>.cfg
Description
It enables or disables the custom soft key X to be displayed in the conference state.
Note: It works only if the values of the parameters
“features.enhanced_dss_keys.enable” and “softkey.X.enable” are set to 1 (Enabled).
Permitted
Values
0-Disabled
1-Enabled
Default
0
Parameter
softkey.X.use.dialtone
[1]
<y0000000000xx>.cfg
Description
It enables or disables the custom soft key X to be displayed in the dial tone (no
numbers entered) state.
Note: It works only if the values of the parameters
“features.enhanced_dss_keys.enable” and “softkey.X.enable” are set to 1 (Enabled).
Permitted
Values
0-Disabled
1-Enabled
Default
0
Parameter
softkey.X.use.dialing
[1]
<y0000000000xx>.cfg
Description
It enables or disables the custom soft key X to be displayed in the dialing state.
Note: It works only if the values of the parameters
“features.enhanced_dss_keys.enable” and “softkey.X.enable” are set to 1 (Enabled).