Yealink T54S

Call Features
279
Parameter
dialplan_replace_rule.url
<y0000000000xx>.cfg
Description
It configures the access URL of the replace rule template file.
For customizing replace rule template file, refer to Replace Rule File Customization.
Note: It works only if the values of the parameters “dialplan.digitmap.enable” and
“account.X.dialplan.digitmap.enable” are set to 0 (Disabled).
Permitted
Values
URL within 511 characters
Default
Blank
[1]
X is from 1 to 100.
Dial Now Configuration
You can configure dial now rules either one by one or in batch using a dial now template.
The following table lists the parameters you can use to configure dial now.
Parameter
dialplan.dialnow.rule.X
[1]
<y0000000000xx>.cfg
Description
It configures the dial now rule (the string used to match the numbers entered by the
user).
When entered numbers match the predefined dial now rule, the IP phone will
automatically dial out the numbers without pressing the send key.
Example:
dialplan.dialnow.rule.1 = 123
Note: It works only if the values of the parameters “dialplan.digitmap.enable” and
“account.X.dialplan.digitmap.enable” are set to 0 (Disabled).
Permitted
Values
String within 511 characters
Default
Blank
Web UI
Settings->Dial Plan->Dial Now->Rule
Parameter
dialplan.dialnow.line_id.X
[1]
<y0000000000xx>.cfg
Description
It configures the desired line to apply the dial now rule. The digit 0 stands for all lines.
If it is left blank, the dial-now rule will apply to all lines on the IP phone.
Note: Multiple line IDs are separated by commas. It works only if the values of the
parameters “dialplan.digitmap.enable” and “account.X.dialplan.digitmap.enable” are
set to 0 (Disabled). It is not applicable to T19(P) E2 IP phones.
Permitted
Values
0 to 16 (for T54S/T48S/T48G/T46S/T46G/T29G)
0 to 12 (for T52S/T42G/T42S)
0 to 6 (for T41P/T41S/T27P/T27G)