It configures the time (in seconds) to wait before dialing an entered number if it
matches part of any string of the digit map for the account X.
If it is set to 0, the IP phone will not dial the entered number if it only a partial match
exists.
The value of this parameter should be greater than that configured by the parameter
“account.X.dialplan.digitmap.interdigit_short_timer”.
For example:
account.1.dialplan.digitmap.string = 1xxT|xxxxx<T1>
account.1.dialplan.digitmap.interdigit_long_timer = 10
account.1.dialplan.digitmap.interdigit_short_timer = 5
When you enter 1, it matches part of two digit maps, the IP phone tries to wait 10
seconds and then dials out 1 if no numbers entered;
When you enter 15, it also matches part of two digit maps, the IP phone tries to wait
10 seconds and then dials out 15 if no numbers entered;
When you enter 153, it also matches part of two digit maps, the IP phone tries to wait
10 seconds. But after waiting for 5 seconds, it completely matches the first digit map
and then immediately dials out 153.
Note: It works only if “account.X.dialplan.digitmap.enable” is set to 1 (Enabled). The
value configured by the parameter “account.X.dialplan.digitmap.interdigit_long_timer”
takes precedence over that configured by the parameter
“dialplan.digitmap.interdigit_long_timer”.
It configures the timeout interval (in seconds) for any string of digit map.
The IP phone will wait this many seconds before matching the entered digits to the
dial plan and placing the call.
Note: It works only if “account.X.dialplan.digitmap.enable” is set to 1 (Enabled). The
value configured by the parameter
“account.X.dialplan.digitmap.interdigit_short_timer” takes precedence over that
configured by the parameter “dialplan.digitmap.interdigit_short_timer”.
To Next Page
Loading...
