Yealink T54S

Call Features
313
Values
the IP phone will automatically answer after you end the current call or cancel the
dialing.
1-Enabled. The IP phone can only automatically answer the incoming call arrived when
the phone is idle. If there is an incoming call arrived when the IP phone is in a call or
dialing, you have to manually pick up the incoming call.
Default
1
Parameter
features.auto_answer_delay
<y0000000000xx>.cfg
Description
It configures the delay time (in seconds) before the IP phone automatically answers an
incoming call.
Note: For the call coming from a SIP account, it works only if “account.X.auto_answer”
is set to 1 (Enabled).
Permitted
Values
Integer from 1 to 4
Default
1
Web UI
Features->General Information->Auto Answer Delay(1~4s)
Parameter
features.auto_answer_tone.enable
<y0000000000xx>.cfg
Description
It enables or disables the phone to play a warning tone when an incoming call is
automatically answered.
Note: For the call coming from a SIP account, it works only if “account.X.auto_answer”
is set to 1 (Enabled).
Permitted
Values
0-Disabled
1-Enabled
Default
1
Web UI
Features->General Information->Enable Auto Answer Tone
Parameter
features.custom_auto_answer_tone.enable
<y0000000000xx>.cfg
Description
It configures the type of auto answer tone.
Note: It works only if “features.auto_answer_tone.enable” is set to 1 (Enabled).
Permitted
Values
0-One beep
1-Double beep
Default
1
Parameter
features.mute.autoanswer_mute.enable
<y0000000000xx>.cfg
Description
It enables or disables auto answer mute feature.
Note: It works only if “account.X.auto_answer” and “features.allow_mute” are set to 1
(Enabled). It is not available to the intercom call.