Yealink T54S

Call Features
327
Default
1
Web UI
Features->General Information->Play Hold Tone
Parameter
features.play_hold_tone.delay
<y0000000000xx>.cfg
Description
It configures the time (in seconds) to wait for the IP phone to play the initial call hold
tone.
If it is set to 30 (30s), the IP phone will wait 30 seconds to play the initial call hold tone
after you place a call on hold.
Note: It works only if “features.play_hold_tone.enable” is set to 1 (Enabled).
Permitted
Values
Integer from 3 to 3600
Default
30
Web UI
Features->General Information->Play Hold Tone Delay
Parameter
features.play_hold_tone.interval
<y0000000000xx>.cfg
Description
It configures the time (in seconds) between subsequent call hold tones.
If it is set to 3 (3s) and “features.play_hold_tone.delay” is set to 30 (30s), the IP phone
will begin to play a hold tone after you place a call on hold for 30 seconds, and repeat
the call hold tone every 3 seconds.
Note: It works only if “features.play_hold_tone.enable” is set to 1 (Enabled).
Permitted
Values
Integer from 3 to 3600
Default
30
Web UI
Features->General Information->Hold Tone Interval(second)
Parameter
features.play_held_tone.enable
<y0000000000xx>.cfg
Description
It enables or disables the IP phone to play the call held tone when a call is held by the
other party.
Permitted
Values
0-Disabled
1-Enabled
Default
0
Web UI
Features->General Information->Play Held Tone
Parameter
features.play_held_tone.delay
<y0000000000xx>.cfg
Description
It configures the time (in seconds) to wait for the IP phone to play the initial call held
tone.
If it is set to 30 (30s), the IP phone will wait 30 seconds to play the initial call held tone
after you are held by the other party.