Yealink T54S

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series IP Phones
394
Description
It configures the value of DTMF payload.
Note: It works only if “account.X.dtmf.type” is set to 1 (RFC2833) or 3 (RFC2833 + SIP
INFO).
Permitted
Values
Integer from 96 to 127
Default
101
Web UI
Account->Advanced->DTMF Payload Type(96~127)
Parameter
account.X.dtmf.info_type
[1]
<MAC>.cfg
Description
It configures the DTMF info type.
Note: It works only if “account.X.dtmf.type” is set to 2 (SIP INFO) or 3 (RFC2833 + SIP
INFO).
Permitted
Values
1-DTMF-Relay
2-DTMF
3-Telephone-Event
Default
1
Web UI
Account->Advanced->DTMF Info Type
Parameter
features.dtmf.repetition
<y0000000000xx>.cfg
Description
It configures the repetition times for the IP phone to send the end RTP Event packet
during an active call.
Permitted
Values
1, 2 or 3
Default
3
Web UI
Features->General Information->DTMF Repetition
Parameter
features.dtmf.duration
[2]
<y0000000000xx>.cfg
Description
It configures the duration time (in milliseconds) for each digit when a sequence of
DTMF tones is played out automatically.
Note: If the time interval between two DTMF digits is less than this value, two or more
same DTMF digits could be identified as one DTMF digit. This may cause the loss of
one or more DTMF digits. For example, 2662 may be identified as 262. If so, you can
modify the value of this parameter to a little lower than the default value.
Permitted
Values
Integer from 0 to 700
Default
100
Parameter
features.dtmf.volume
<y0000000000xx>.cfg