Yealink T54S

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series IP Phones
402
VQ-RTCPXR Display Configuration
The following table lists the parameters you can use to configure VQ-RTCPXR display.
Parameter
phone_setting.vq_rtcpxr.states_show_on_web.enable
<y0000000000xx>.cfg
Description
It enables or disables the voice quality data of the last call to be displayed on web
interface at path Status->RTP Status.
Permitted
Values
0-Disabled
1-Enabled
Default
0
Web UI
Settings->Voice Monitoring->Display Report options on Web
Parameter
phone_setting.vq_rtcpxr.states_show_on_gui.enable
<y0000000000xx>.cfg
Description
It enables or disables the voice quality data of the last call or current call to be
displayed on the LCD screen. You can view the voice quality data of the last call on the
phone at the path Menu->Status->More->RTP (RTP Status). You can view the voice
quality data of the current call by pressing RTP/RTP Status soft key during a call.
Permitted
Values
0-Disabled
1-Enabled
Default
0
Web UI
Settings->Voice Monitoring->Display Report options on phone
Parameter
phone_setting.vq_rtcpxr_display_start_time.enable
<y0000000000xx>.cfg
Description
It enables or disables the phone to display Start Time on the LCD screen.
Note: It works only if “phone_setting.vq_rtcpxr.states_show_on_gui.enable” is set to 1
(Enabled).
Permitted
Values
0-Disabled
1-Enabled
Default
1
Web UI
Settings->Voice Monitoring->Report options on phone->Start Time
Parameter
phone_setting.vq_rtcpxr_display_stop_time.enable
<y0000000000xx>.cfg
Description
It enables or disables the phone to display Current Time or Stop Time on the LCD
screen.
Note: It works only if “phone_setting.vq_rtcpxr.states_show_on_gui.enable” is set to 1
(Enabled).
Permitted
Values
0-Disabled
1-Enabled