Yealink T54S

Advanced Features
463
Permitted
Values
String
Default
Blank
Parameter
blf.enhanced.callin.idle.action
<y0000000000xx>.cfg
Description
It configures the behavior when pressing the BLF/BLF list DSS key if the monitor is idle
and monitored user is ringing.
This value uses the same macro action string syntax as an Enhanced DSS key.
Example:
blf.enhanced.callin.idle.action = newcall
Note: It works only if “blf.enhanced.callin.enable” is set to 1 (Enabled). It is not
applicable to T19(P) E2 IP phones.
Permitted
Values
String
Default
Blank
BLF Key LED/Icon and Behavior for Call-out State Configuration
The following table lists the parameters you can use to configure BLF key LED/icon and Behavior for
call-out state (the monitored user is calling out).
Parameter
blf.enhanced.callout.enable
<y0000000000xx>.cfg
Description
It enables or disables the custom configuration when the monitored user is calling out.
Note: It is not applicable to T19(P) E2 IP phones.
Permitted
Values
0-Disabled
1-Enabled, the IP phone will display the custom BLF/BLF List DSS key LED status/icon
colors and perform the custom behavior when pressing the BLF/BLF List DSS key.
Default
0
Parameter
blf.enhanced.callout.led
<y0000000000xx>.cfg
Description
It configures the custom BLF/BLF List DSS key LED status/icon colors when the
monitored user is calling out.
This value uses the same macro action string syntax as an Enhanced DSS key.
Example:
blf.enhanced.callout.led = $LEDg1000o$
For
T54S/T52S/T46G/T46S/T42G/T42S/T41P/T41S/T40P/T40G/T29G/T27P/T27G/T23P/T23
G/T21(P) E2 IP phones, the BLF/BLF list DSS key LED glows green for 1000ms and then
goes out.
For T48G/T48S IP phones, the BLF/BLF List DSS key field displays a green icon for