Yealink T54S

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series IP Phones
74
contained in the configuration file and set to 1.
If the IP phone reboots repeatedly after it is set to 1, you can try to set
“static.auto_provision.power_on" to 0 (Off).
Permitted
Values
0-Disabled
1-Enabled
Default
Blank
Parameter
features.action_uri_force_autop
<y0000000000xx>.cfg
Description
It enables or disables the IP phone to end the call for triggering auto provisioning
immediately when receiving an HTTP or HTTPS GET request with variable value set to
AutoP during a call.
Note: It works only if “features.action_uri.enable” is set to 1 (Enabled).
Permitted
Values
0-Disabled, the IP phone will trigger auto provisioning after the call.
1-Enabled
Default
0
Parameter
static.auto_provision.power_on
<y0000000000xx>.cfg
Description
It triggers the power on feature to on or off.
Permitted
Values
0-Off
1-On, the IP phone will perform auto provisioning when powered on.
Default
1
Web UI
Settings->Auto Provision->Power On
Parameter
static.auto_provision.repeat.enable
<y0000000000xx>.cfg
Description
It triggers the repeatedly feature to on or off.
Permitted
Values
0-Off
1-On
Default
0
Web UI
Settings->Auto Provision->Repeatedly
Parameter
static.auto_provision.repeat.minutes
<y0000000000xx>.cfg
Description
It configures the interval (in minutes) for the IP phone to perform auto provisioning
repeatedly.
Note: It works only if “static.auto_provision.repeat.enable” is set to 1 (On).
Permitted
Values
Integer from 1 to 43200
Default
1440