NeoGate TA410/810 User Manual
36/51
2) Advanced Mode
When Simple Mode is set to “No”, you can check the advanced settings.
Figure III-4-4 Port→IP Advanced Mode
Table III-4-3 Port→IP Settings
Inbound Caller Pattern
Match the prefix of caller ID for incoming calls.
Hover the pointer over to read tips.
Enable Call Back
Choose whether call back is enabled. NeoGate TA allows caller
A to dial an inbound route number, and after hearing the ring, A
can hang up the call to cut off the call, then NeoGate TA will call
back to A.
Hotline
Set the hotline number. If hotline number is configured, TA will
route the incoming call to the hotline number directly.
Two Stage Dial
Enable it to get the customized two stage dial tone before
dialing out, it’s disabled by default.
Dial Pattern Template Choose the Dial Pattern template.
IP→Port
On this page, you can configure how to route the calls from VoIP trunk to a PSTN number.
1) Simple Mode
All you need to configure in simple mode is to choose the dial pattern template.
NeoGate TA will allow all incoming calls and route the calls to the destination without
any modification.
To Next Page
Loading...
Need help?
General
