NeoGate TA410/810 User Manual
49/51
Figure III-4-19 Tone Zone Settings
Users may also configure the tone zone according to the national standard by selecting
"User custom for Tone Zone". Please refer to the document below and configure the tone
zone settings on NeoGate TA:
http://www.itu.int/ITU-T/inr/forms/files/tones-0203.pdf
Figure III-4-20 Customize Tones
Table III-4-13 Description of Tone Zone Settings
Country
Choose the country to get pre-programmed tone zone settings or
choose "User custom for Tone Zone" to configure the settings
Ring Cadence
Configuration option for all FXO ports ring cadence for all incoming
calls.
Dial Tone Prompt tone of off-hook dial tone.
The tone sent to caller when ringing is on.
Used for busy line prompt.
Call-Waiting Tone Used for notification in call waiting.
Congestion Tone
Used to indicate that an invalid code has been dialed, or that all
circuits (trunks) are busy and/or the call is unroutable.
Used for the second stage dial tone.
To Next Page
Loading...
Need help?
General
