Network Errors
Code Message Chapter or
Section
600 Unable to connect to the server.
Check the network settings and configuration.
Chapter 19
601 Has not connect with ftp server yet.
Confirm the network settings and connection.
Chapter 19
602 This ftp function in not supported. –
603 FTP Error: Client Handle
Confirm the network settings and connection.
Chapter 19
605 Cannot send a mail.
Confirm the network settings and connection.
Chapter 19
608 Failed to acquire time from SNTP server.
Confirm the network settings and connection.
Chapter 19
Execution Errors (650 to 799)
Code Message Chapter or
Section
650 Data is invalid. –
653 Can not be executed while running.
Press START/STOP key to stop acquisition.
–
654 Cannot manipulate files while image printing is in progress.
Wait until image printing is complete.
–
656 Calibration failure.
Disconnect the input and execute again.
If it fails again, servicing is necessary.
–
657 SD Card recording is valid when the sampling rate is slower than the values shown below.
1CH : 1MS/s(1us)
2CH : 500kS/s(2us),
3 - 5CH : 200kS/s(5us)
6 - 10CH : 100kS/s(10us)
–
661 Balancing failed. –
664 Go-Nogo is available while Trigger Mode is
- ‘Single’ or ‘Normal’
- ‘Auto’ (Faster than 50ms/div)
4.1,
1
chapter 13
1
666 Failed to measure statistics.
Waveform data may be missing.
If Cycle Statistics is specified, the instrument may be configured in a way that fails to detect the cycle.
8.3
1
667 Executing file access.
Abort or wait until it is complete.
–
668 Image is being printed or saved.
Wait until the execution of the command is complete.
–
669 Cannot be executed when the action mode is ON. 3.1,
1
3.2
1
671 Cannot be executed when a SD Card recording is ON. 3.1,
1
3.2
1
672 Cannot be executed when the time base setting is to be an External clock. 3.1,
1
3.2
1
673 Because there are too many channels, it can’t start in the length of the present record. Chapter 2
1
674 Average practice can’t be done because the record length of the history exceeds the record length that it
can be carried out.
Chapter 17
1
675 Average practice can’t be done because the record length of the history exceeds the record length that it
can be carried out.
Chapter 17
1
676 Set the trigger mode to On Start for SD Card recording. 4.1
1
677 Cannot do while selftest is executing. 5.3
679 Cannot start at the current record length.
Shorten the record length or meet the following condition.
* Set the trigger mode to Auto, decrease T/Div to less than 100 msec/div to enable roll mode.
* Set the trigger mode to Single or On Start.
3.1,
1
4.1
1
680 Averaging mode is not possible when the trigger mode is Single or On Start.
Change the trigger mode.
4.1
1
684 Cannot start when the time base set to external clock while Acq. Mode set to envelope. 3.1
1
685 Cannot start when roll mode display while accumulate mode set to ON.
Turn Off accumulate.
5.3
1
5.2 Messages and Corrective Actions
1 User’s Manual, IM DL350-02EN
To Next Page
Loading...
Need help?
General
