YOKOGAWA ROTAMETER RAMC

Contents
1. Introduction .........................................................................................1-1
1.1 Target group ......................................................................................................1-1
1.2 Applicable documents .....................................................................................1-1
1.3 General items .................................................................................................... 1-1
2. About PROFIBUS PA ..........................................................................2-1
2.1 Outline ..............................................................................................................2-1
2.2 Internal Structure of RAMC PROFIBUS PA ..................................................2-1
2.3 Logical Device Structure ................................................................................2-1
3. Installation ..........................................................................................3-1
3.1 Wiring System Conguration .........................................................................3-1
3.2 Connection of Devices ...................................................................................3-1
4. Start of Operation ..............................................................................4-1
4.1 Integration of GSD ..........................................................................................4-1
4.2 Important Device Settings ............................................................................4-1
4.3 Cyclic Data Exchange .....................................................................................4-2
4.4 Setting of Write Protection .............................................................................4-2
4.5 Using the Keys ................................................................................................4-2
4.6 Menu Structure ................................................................................................4-3
5. Block Setting ......................................................................................5-1
5.1 Parameters and Initial Settings .....................................................................5-1
5.2 Physical Block (PB) Parameters ....................................................................5-1
5.3 Analog Input (AI) Block Parameters .............................................................5-2
5.4 Transducer Block (TB) Parameters ...............................................................5-3
6. Status and Diagnostic Information ..................................................6-1
6.1 Status description ...........................................................................................6-1
6.2 Diagnostics ......................................................................................................6-3
6.3 Status impacts of Alarm settings ..................................................................6-4
<1CONTENTS>
i
All Rights Reserved. Copyright © 2006, Rota Yokogawa
IM 01R01B02-01E-E 5th edition October 01, 2020 -00