SECTION 8 - MICROPANEL
JOHNSON CONTROLS
151
Form 201.47-ICOM1
Issue date: 17/11/2022
8
OPTIONS REMOTE CURRENT LIMIT INPUT
◄ ► 4.0 TO 20.0 MILLIAMPS
The default setting for Remote Current Reset is
DISABLED. This display only appears if the remote
current limit option is enabled under the Unit Setup
Mode.
Remote sound limit selection
Remote sound limit from an external source may be
tied directly into the chiller microprocessor board.
OPTIONS REMOTE SOUND LIMIT INPUT
◄ ► XXXXXXXXXXXXXXXXXXXX
Selections may be made for DISABLED (no signal), 0
VDC to 10 VDC, 2 VDC to 10 VDC, 0 mA to 20 mA,
and 4 mA to 20 mA.
OPTIONS REMOTE SOUND LIMIT INPUT
◄ ► DISABLED
OPTIONS REMOTE SOUND LIMIT INPUT
◄ ► 0.0 TO 10.0 VOLTS DC
OPTIONS REMOTE SOUND LIMIT INPUT
◄ ► 2.0 TO 10.0 VOLTS DC
OPTIONS REMOTE SOUND LIMIT INPUT
◄ ► 0.0 TO 20.0 MILLIAMPS
OPTIONS REMOTE SOUND LIMIT INPUT
◄ ► 4.0 TO 20.0 MILLIAMPS
The default setting for Remote Sound Limit is
DISABLED. This display will only appear if the re-
mote sound limit option is enabled under the Unit Set-
up Mode.
Low ambient cutout enable/disable
The low ambient cutout may be enabled or disabled.
When enabled, the chiller cuts OFF when the low am-
bient cutout is reached. When disabled, the chiller will
run at any temperature.
OPTIONS LOW AMBIENT TEMPERATURE CUTOUT
◄ ► ENABLED
OPTIONS LOW AMBIENT TEMPERATURE CUTOUT
◄ ► DISABLED
The default setting for the low ambient cutout is EN-
ABLED.
Variable water outlet control enabled/disabled
This option is for the purpose of Edo-Design compli-
ance, the default setting for this option is DISABLED.
OPTIONS VARIABLE WATER OUTLET CONTROL
◄ ► ENABLED
OPTIONS VARIABLE WATER OUTLET CONTROL
◄ ► DISABLED
To Next Page
Loading...
