1-3
• Single and dual chemistry configurations.
• Minimal sample preparation.
• Sample aspiration from a variety of tubes.
• Selectable sample aspiration volume (5 to 65 µL).
• Sample results in about one minute.
• Fluid sensing minimizes carry-over.
• Fluid design washes inside and outside of sipper tube.
• Programmable automatic calibration.
• Selectable concentration units, including g/L, mg/L, mmol/L, %(w/v).
• Liquid crystal display and built-in data printer.
• RS-232 serial port.
• Turntable interface circuitry installed.
• User-accessible service and diagnostic menus.
To Next Page
Loading...
